1. Keep the cutting machine clean: After use, the dust and debris on the cutting machine should be cleaned in time to avoid the cutting machine rust or jamming.
2. Check the tool: regularly check the wear of the tool, if the tool wear is serious, it should be replaced in time.
3. Check hydraulic oil: regularly check the oil level and oil quality of hydraulic oil, if the oil level is too low or the oil quality deteriorates, the hydraulic oil should be added or replaced in time.
4. Check the circuit: regularly check the circuit of the cutting machine to ensure that the circuit is well connected without short circuit or open circuit phenomenon.
5. Regular lubrication: Regularly lubricate the moving parts of the cutting machine to reduce friction and wear.
6. Storage: When not in use, the cutting machine should be stored in a dry, ventilated and non-corrosive place to avoid moisture or damage.

Safety Precautions:
Wear appropriate personal protective equipment, including safety glasses and gloves.
Ensure that the work area is clear of obstacles and that you have a stable and level surface.

Select the Correct Rebar Bender:
Choose a rebar bender that suits the size and type of rebar you are working with.

Mark the Bending Point:
Use a marker or chalk to mark the point on the rebar where you want the bend to occur. Measure and mark accurately to ensure precision.

Secure the Rebar:
Place the rebar securely into the bending machine, ensuring that it is properly aligned with the bending point.

Adjust the Bending Angle:
Set the bending angle on the rebar bender to the desired angle for your specific construction requirements. This is usually done using adjustment knobs or levers on the machine.

Operate the Rebar Bender:
Depending on the type of rebar bender, you may need to manually operate a lever or turn a crank to bend the rebar.

Check the Bend:
After bending, check the angle and shape of the bend against your specifications. If adjustments are needed, repeat the bending process.
Repeat as Needed:

If multiple bends are required, repeat the process, adjusting the bender as necessary for each bend.

Remove the Rebar:
Once you have achieved the desired bends, carefully remove the rebar from the bender.